Mads Electronics Smarty Tuner
DODGE
Ram Cummins 2003-07
Eng: 5.9 (04-07)
2004 - 2007 
Part # S-06b 
$685.00

Fast guide to Smarty’s special

Features

The MADS Electronics tuning software is well known as CaTCHER software MADS Electronics original products were EPROMs and Flash-EPROMs (or “chips”) which could be installed in place of the original OEM EPROMs and Flash-EPROMs located in the vehicle’s on-board control module. These chips, just like the tuners of today, keep the entire vehicle safety and emissions systems intact, but modify the fuel injection settings to deliver dramatic power, torque and driveability improvements.

Also the fuel consumption is one of the most important point of MADS Electronics research.
CaTCHER softwares can be used to reduce fuel consumption up to 15% depending on the driving condition. Saving money and reducing the vehicle emissions.

With the advent of OBD-II vehicle control module in the early 1990’s, most domestic vehicle manufacturers
installed under-dash ports (“ALDL ports”) which allowed dealers and service techs to “re-flash” the
vehicle's control module to change engine settings without replacing any chip.
So today, instead of chips, MADS Electronics primarily sells hand-held tuners which achieve the same
dramatic drivetrain improvements, without the hassle of popping the hood, pulling out the vehicle control
module and replacing a chip. Installation is quick and easy, taking just 2 minutes and requiring no tools or
mechanical skills whatsoever.

- CaTCHER softwares inside

- Ten different performance levels.

- Fastest download in the industry, a typical ECM update takes just two minutes.

- ABS tire height updates in just seconds.

- Not traceable by the Dealer in the stock setting. Smarty leaves no footprint.

- Cold weather 3 Cylinder High Idle is enabled in all softwares .

- Reads Diagnostic Trouble Codes in plain text.

- No tools required, no fuses to pull.

- USB build in for simple updates .

- Most complete keyboard in the industry.

- Relyabel, it works off your OEM ECM hardware.

Fast guide to Smarty's softwares

Smarty for the 2003 to 2007 Cummins Common Rail is now shipping.



1) Ten different -CaTCHER- performance softwares for each truck. 2) Smarty leaves NO trace at all of itself once the ECM is set back to stock. 3) ABS / Speedo recalibration in steps of one tenth of an inch. 4) Code reader, codes are displayed as Pxxxx and in plain English. 5) Fastest download, up to three times faster than the competition. 6) Build in USB port for internet updates.

1) The horsepower settings. Just like the VP Smarty does, except #0, all other softwares have a modified "Torque management" ( TQM ). The throttle response is greatly improved but is set to a save limit. With "Save" I mean save for your tranny and rest of the driveline.

SW # 0 : Half power SW # 1 : 30 Hp increase, with added timing . SW # 2 : 60 Hp increase, no added timing. SW # 3 : 60 Hp increase, with added timing. SW # 4 : 90 Hp increase, no added timing. SW # 5 : 90 Hp increase, with added timing. SW # 6 : 130 Hp increase, no added timing. SW # 7 : 130 Hp increase, with added timing. SW # 8 : 170 Hp increase, no added timing.*** SW # 9 : 170 Hp increase, with added timing.***

*** 170 Hp Only for the 04.5's and up. SW's # 8 & #9 for the 03-04 trucks are similar to #6 and #7 but have more